General
view showing the TR4A rack fitted to a mounting bracket which is braced
forward to the old steering box mounting and laterally to the rear bolt
holding the bumper dumb-irons.
Note the alloy rack mountings (Moss Part No. TT3255) which are much superior to the rubber mountings
Note the alloy rack mountings (Moss Part No. TT3255) which are much superior to the rubber mountings
The
mounting is in 3 parts - the two side brackets and the top plate. There
is NO flexing in this mounting and it is very strong. No chassis drilling
is required. The underside of the top plate is reinforced with an angle
stiffener (see next pic)
A view from below
showing the stiffener and how the rack mountings bolt the device together.
It would be best to get an engineer to carry out the welding. Engineers
certification is your responsibility for registration purposes.